LogTag STX-50

STX-50 probe extension cable

The STX-50 is a 5 m long extension cable for all sensors in the ST100 and ST10 series.

The female end of the cable, which accepts the plug of the sensor (suitable for both ST100 and ST10 sensors), is fitted with a flexible sleeve that provides the connection point with IP61 protection when the sensor is plugged in.

STX-50 - 5 m extension cable

28 mm sleeve length, intended as an extension for ST10 and ST100 series probes*

*Only one extension per logger

• Logger-extension connection: IP61 (with vertically suspended logger)
• Connection of the extension probes: IP61 (-46 °C to 74 °C)
• Cable length 5 m = article no. STX-50

Only probes of the respective series may be used with the corresponding LogTag® data loggers; connecting other sensors may lead to measurement errors.

Note: Sensors of the ST100 series can be exchanged between the LogTag data loggers without recalibration and without affecting the specified nominal accuracy. However, if a particular combination of data logger and ST100 probe is calibrated to achieve a higher accuracy, this combination must remain paired for measurements or the higher accuracy cannot be guaranteed. In this case, the accuracy is not transferable to other data loggers or ST100.